top of page
20250421_185451.png

Helium Leak Testing - High Pressure Components

Helium leak testing at 1000 bar

HELIUM LEAK TESTING

( Hydrogen Components - 1000 bar )

Hydrogen applications demand stringent leak testing of the components to be tested at ultra high pressures upto 1000 / 1200 bar. The pressure needs to be ramped up in a phased manner during the leak testing process. Our Helium Leak testing machine developed for hydrogen application can be used for testing of Hydrogen components at desired set pressures.

Technical Specifications

  • Leak Detection Rate             :  1 x 10 E -4 mbarl/s

  • Cycle Time                            : 60 Secs

  • Leak Testing Pressure           : 1000 bar

  • Calibration routine                 : Automatic

  • Background suppression     : Auto Zero

  • Helium Mixing ratio               : 5%

  • Helium Recovery                  : > 95%​​​​​​​​​

helium leak tetsing for CNG cylinder valves

HELIUM LEAK TESTING

( Cylinder Valves - 350 bar )

Cylinder Valve Leak Testing demand stringent leak testing of the Valve components to be tested at high pressures upto 350 bar. Two types of Leak testing is performed - Internal Leak ( With Valve Closed ) & External Leak Testing ( With Valve Open ). Challenge to perform the Test at High speed testing with minimum cycle time. Also min Helium consumption is ensured by Internal Gas mixing and monitoring system. 

Technical Specifications

  • Leak Detection Rate             :  1 x 10 E -4 mbarl/s

  • Cycle Time                            : 30 Secs

  • Leak Testing Pressure           : 350 bar

  • Calibration routine                 : Automatic

  • Background suppression     : Auto Zero

  • Helium Mixing ratio               : 5%

  • Helium Recovery                  : > 95%​​​​​​​​​

Helium leak testing at 300 bar

HELIUM LEAK TESTING

( CNG Components - 300 bar )

Helium Leak Testing application for CNG components such as HP Regulators in Automotive requires Leak testing not only at high pressure ( 300 bar ) but also during operation with coil operated inside the chamber. Internal , External and whole body leak testing is performed during the Auto cycle check. Other parts such as Receptacle, HP Tubes etc are also tested with helium Leak testing method.

Technical Specifications

  • Leak Detection Rate             :  1 x 10 E -4 mbarl/s

  • Cycle Time                            : 60 Secs

  • Leak Testing Pressure           : 300 bar

  • Calibration routine                 : Automatic

  • Background suppression     : Auto Zero

  • Helium Mixing ratio               : 5%

  • Helium Recovery                  : > 95%​​​​​​​​​

Leckpreufung Systems

PHOENIX INDUSTRIAL SOLUTIONS

Contact: +(91)- 9822517523

Phoenix Industrial Solutions
bottom of page